The table below describes which combinations of Opmantek FirstWave products are tested and work well with what versions of NMIS 9 and MongoDB.
...
NMIS 9 compatibility list:
Anchor | ||||
---|---|---|---|---|
|
Product | Product Version | MongoDB Version (bold: recommended) | Operating | Notes |
---|---|---|---|---|
NMIS | >= 9.0.0 | 3.4, 3.6 |
| RHEL 8 is supported from NMIS version 9.2.1 If install of NMIS 9 fails due to failure to install package WWW::Mechanize, pre-install WWW::Mechanize before installing NMIS:
|
NMIS | >= 9.4.0 | 3.4, 3.6, 4.2 | ||
NMIS | >=9.4.4 | 3.4, 3.6, 4.2 |
| OS's supported prior are also still supported in NMIS9 9.4.4 |
NMIS | >=9.4.7 | 3.4, 3.6, 4.2 |
| Redhat 9 support was introduced in NMIS9 9.4.7. OS's supported prior are still supported |
Release 9.0.4 of NMIS introduces the smarter non-interactive installation mode.
*CentOS 8 support has been withdrawn due to CentOS 8 being end of maintenance on 31 Dec 2021, your CentOS target should be CentOS 7 https://wiki.centos.org/About/Product
...
FirstWave Installer
...
Some notes that are common for all Opmantek FirstWave Applications:
- The Opmantek FirstWave installer can can be preseeded before the installer is invoked.
- On CentOS and RHEL, always check the status of firewalld and selinux when unable to connect via http |or https. During the installation, the installer prompts to disable selinux.
...
Status | ||||
---|---|---|---|---|
|
opFlow opFlow
...
opFlow Documentation
opFlow 4.X Compatibility list:
Product | Product Version | NMIS Version | MongoDB Version (bold: recommended) | Notes |
---|---|---|---|---|
opFlow | >= 4.0.0 | >= 9.4.6 | 4.2 |
Status | ||||
---|---|---|---|---|
|
...